02-20-2010 07:33 AM - edited 03-15-2019 09:30 PM
Hello Guys,
I have a lab setup with 2 2621XM routers with VWIC-1MFT-T1 1-Port Multiflex Voice Cards in them with a crossover cable between the devices. When I go under the controller interface below to use the PRI_GROUP or DSO-GROUP commands they are not available. I only see why what is listed below. Why is that?
VoiceGateway(config)#controller t1 0/1
VoiceGateway(config-controller)#?
Controller configuration commands:
cablelength Specify the cable length for a DS1 link
channel-group Specify the timeslots to channel-group mapping for an
interface
clock Specify the clock source for a DS1 link
crc-threshold Specify how many CRC errors per second to be treated as
severely errored second (SES)
default Set a command to its defaults
description Controller specific description
detect Enable detection of loopback request
exit Exit from controller configuration mode
fdl Specify the FDL standard for a DS1 data link
framing Specify the type of Framing on a DS1 link
guard-timer Guard timer (0-20) for xcsp calls - timer duration and
accept/reject on expiry
help Description of the interactive help system
linecode Specify the line encoding method for a DS1 link
loopback Put the entire T1 line into loopback
mode Configure the controller mode
no Negate a command or set its defaults
shutdown Shut down a DS1 link (send Blue Alarm)
02-20-2010 07:54 AM
You need either an AIM DSP, or NM-HDV-xxx
No DSP, no voice ports.
02-20-2010 08:15 AM
Is there anything I need to do in order to get my card to use the DSP's on the Module?I do have a Cisco NM-1V Voice Network Module VIC in that router but, do not have card plugged in that slot. I have it inserted in regular slot. Do I need to config my controller to use those DSP's on the module or something?
02-20-2010 01:21 PM
That does support VWIC.
Must use HW indicated above.
02-20-2010 01:50 PM
I looked at the cost of the DSP's can not afford them to run the VWIC'S I
purchased. Is the any cards that I can buy that will work with the equiptment I told you I have? Maybe there are PRI cards that I can purchase to get the training I need for DSO-GROUPS and PRI-GROUPS.
02-21-2010 04:28 AM
Check the popular auction site for savings.
Please rememeber to rate useful posts clicking on the stars below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide