"Network out of order" on inbound calls

[florianfetty]

Hello everybody!

I'm to set up a banch office in the UK with Cisco 1800 as a voicegateway (h323) to interact with CUCM 6.0!

Outbound calls are working but inbound ones get dropped. The output of debug isdn q931 is "Network out of order". I can ping CUCM, so I don't know what could be the problem!?

Best Regards; Florian

[florianfetty]

Just for additional information: I`m austrian and don't know if the problems occur since I did the BRI-configuration as for an austrian ISDN:

interface BRI0/1/1

description *** Voice ***

no ip address

no logging event link-status

isdn switch-type basic-net3

isdn overlap-receiving T302 5000

isdn twait-disable

isdn point-to-point-setup

isdn incoming-voice voice

isdn send-alerting

isdn sending-complete

isdn static-tei 0

[jbarcena]

Could you please upload the debug isdn q931, debug voice ccapi inout and the show run of the config?

[mhering8650]

Is this a BRI Line or PRI line?

[florianfetty]

Hi everybody!

It's BRI! Attached you'll find the output of isdn q931 and ccapi inout as well as the sho run of the router! The gateway`s IP on callmanager-side is 172.16.63.253!

Many thanks in advance!

[Steellllllllll0]

Hi,

Which interface are you using as an h323 voip interface ?

I dont see it in your configuration...

[florianfetty]

It`s interface vlan8!

BR

[Steellllllllll0]

Hi,

Sorry i missed that one...try adding h323-gateway voip interface and also if you could post a debug of your dial-peers...

[florianfetty]

Hi!

It doesn't work also with adding the command you told me! Attached there is a debug voip dialpeer all!

BR

[jbarcena]

Could you please also upload a CCM detailed trace?

I would like to check if the CCM server is receiving something...

[Steellllllllll0]

Hi,

Could you provide output from the following commands:

show voice iec description

debug ip tcp transaction

debug cch323 h225

thanks !!

[florianfetty]

Hi everybody!

We managed to fix the problem ourselves! There was NAT enabled between the branch office and the headquarters, which manipulated the voice gateway`s IP address so the callmanager didn`t react on incoming packages!

Here`s how we figured that out:

On CUCM CLI I enabled a "utils network capture 172.16.63.253" -> no packets received by CUCM! Since you cannot enable a capture for only ICMP I used a little trick! I enabled "utils network capture port 23" - well, CUCM doesn't support telnet at all BUT it sees incoming telnet-requests! Since the sender`s IP didn`t match the gateway`s IP, there has to be some NAT on the WAN-link! After turning off the NAT (from which we actually didn`t know that it was turned on ;-) ) everything was working normal!

Thanks for your fast replies!

Best regards; Florian