"Unknown number" on outbound calls

[billkemmer]

Hello,

I'm trying to configure my first CME and I've run into a strange problem. I have configured several dial peers in CME for outbound calling, yet when I dial the "8" for an outbound leading digit, I go right to a busy and the screen says "unknown number". Calls to other IP phones work fine, but I cannot get the system to allow me to dial out. Any thoughts are appreciated.

Thank you.

[Jeffrey Knuckle]

Do you have the following command under Telephony-service?

secondary-dialtone 8

[sheepate]

can you post all dial-peer configs and telephony-service section?