07-30-2010 04:07 PM - edited 03-16-2019 12:01 AM
Hello all,
Brought up a remote office this morning with a 2821 router/voice gateway. The PRI is up and running fine and is registered with remote Callmanager over MGCP. However, I am trying now to register the NM-HDA-4FXS in the same router, but cannot seem to get it working. I have it defined in the gateway config in my call manager, but it is not registering. I suspect that I need to "tell" it it needs to register with the callmanager like I have to do with the T1 controller and resulting serial interface, but I don't see what commands are available to do that for the NM-HDA-4FXS or resulting voice ports. Does anyone know?
Router is a Cisco 2821, IOS version is 12.4(11)T2. CCM version is 6.1.3000-1.
Thanks,
Chris
Solved! Go to Solution.
08-02-2010 07:46 AM
Chris,
You need to have POTS dial-peers for the analog ports. This should suffice:
dial-peer voice 100 pots
port 1/0/1
service mgcpapp
You can verify with:
sh mgcp end
If you have MGCP CCM config server enabled, if that's working properly, it should have added that for you, with a dial-peer ID of 999something.
ccm config
ccm config server
'sh ccm' will let you know if the config downloading is failing.
-Steve Holl
08-02-2010 07:46 AM
Chris,
You need to have POTS dial-peers for the analog ports. This should suffice:
dial-peer voice 100 pots
port 1/0/1
service mgcpapp
You can verify with:
sh mgcp end
If you have MGCP CCM config server enabled, if that's working properly, it should have added that for you, with a dial-peer ID of 999something.
ccm config
ccm config server
'sh ccm' will let you know if the config downloading is failing.
-Steve Holl
08-02-2010 10:18 AM
Steven,
Thanks! The dial-peer is exactly what I needed. I had the card shutdown when I did the inital MGCP setup and config download, so I suspect that that is why the dial peers didn't get automatically created like they do on my VG224s.
It's working great now.
Thanks,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide