Routing calls from CUCME router, through non-CUCME router, to PSTN
I have a VoIP exam coming up, and part of this exam will require us to configure a site with two routers and two switches. The first router (R1) is not running CUCME and is connected directly to the PSTN. The second router (R2) is running CUCME and is connected to the first router. Each router has a switch connected to it, and each switch has an IP phone connected.
Is there any special configuration needed to route calls from R2, to R1, then to the PSTN or to allow phones connected to R1 register with R2?
I've spent a couple hours searching, but haven't been able to find any help. If anyone could point me in the right direction, it would be greatly appreciated.
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...