sccp plar phones not automatically dialing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-04-2008 05:10 AM - edited 03-15-2019 01:02 PM
I have an issue when I pick up an analog phone, at first all I get is a dial tone but when I hang it up and pick it up again, then it dials. It is connected to a vg224 and I have the sccp plar dial XXXX commands in there. This really seems to happen more when the phone hasn't been picked up in a while. Anybody run into this issue? The version of IOS on the VG is 12.4(9)T6
Thanks
- Labels:
-
Other IP Telephony
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-04-2008 05:52 AM
if u have this config with FXS port to an analog phon try to make the config like
under the fxs port do:
connection plar [number]
and have a look at the following link
http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a008009431b.shtml
good luck
if helpful rate
