SG3 fax connected to VG224 running SCCP

[mkulovainio]

Hi!

I have a SG3 fax connected to a VG224 running SCCP and fax-relay, I have also tried with fax pass-trough without success. Does anyone know of this is a supported setup or do I have to convert to MGCP or use ATA etc...any ideas would be appriciated.

Thanks

Mattias

[#2]

If modem pass-through is used to send SG3 faxes and Cisco or T.38 fax relay is used to send G3 faxes, you must configure both modem pass-through and fax relay.

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t4/sg3spoof.html