Hello all,
Can anyone provide the detailed step-by-step procedure of SIP Dial Rule Configuration for PLAR on ATA 187?
Please do not refer me to SIP Dial Rule section of CUCM Admin Guide, which is just a waste of time and is not informative at all for me. All it provides is confusing and useless informations, nothing to the point.
I want my Analog phone, which is attached to ATA 187, to automatically dial 9003 immediately after it goes off-hook.
CUCM Version: 8.6(2a)
ATA 187 Firmware: APPATA187.9-2-1-0.img.sgn (SIP)
Thanks in advance.