Hi all..
I've been into a problem for last couple weeks and I couldn't get out... so I need help and I really expect get some answer from you guys.
In my company there is a tool for recording calls, that solution is based in Built-in Bridge and the CUCM configures the IP Phones to fork their RTP flow to a Voice recorder encountered in their site. Until now it's ok. However, if the link beetween the Central site and the Branch site get down the router at branch site enter in SRST mode and assumes the function to register and keep the communication possible internally. And now, how can I configure the media forking to send the RTP stream to a recorder server?
I've been reading many of whitepapers talking about CUBE and I've tried a lot of configurations to make that possible, creating many of dial-peers, but anything hasn't work. One of the configurations I've tried you can see bellow.
! media class 3 recorder parameter media-recording 3000 ! dial-peer voice 1000 voip session protocol sipv2 incoming called-number 89..$ media-class 3 voice-class codec 1 ! dial-peer voice 2000 voip destination-pattern 89..$ session protocol sipv2 session target ipv4:192.168.2.242* voice-class codec 1 ! dial-peer voice 3000 voip description THIS IS THE FORKING DIAL-PEER destination-pattern 9999 signaling forward unconditional session protocol sipv2 session target ipv4:192.168.2.242* session transport tcp voice-class codec 1 voice-class sip options-keepalive supplementary-service pass-through ! *(where the voice recorder address is 192.168.2.242)
Someone can give me a idea? Is that make sense? Am I doing wrong? Thinking wrong?
Best regards.
Accepted Solutions
