Hey,
So here is my current configuration.
application
global
service alternate default
!
ccm-manager fallback-mgcp
ccm-manager redundant-host X.X.X.X
ccm-manager mgcp
ccm-manager config server X.X.X.X
!
mgcp
mgcp call-agent X.X.X.X service-type mgcp version 0.1
mgcp rtp unreachable timeout 1000 action notify
mgcp modem passthrough voip mode nse
mgcp package-capability rtp-package
no mgcp package-capability res-package
mgcp package-capability sst-package
no mgcp package-capability fxr-package
mgcp package-capability pre-package
no mgcp timer receive-rtcp
mgcp sdp simple
mgcp fax t38 inhibit
mgcp rtp payload-type g726r16 static
mgcp bind control source-interface GigabitEthernet0/0
mgcp bind media source-interface GigabitEthernet0/0
!
mgcp profile default
!
call-manager-fallback
secondary-dialtone 9
max-conferences 8 gain -6
transfer-system full-consult
limit-dn 7940 2
limit-dn 7960 2
ip source-address X.X.X.X port 2000
max-ephones 20
max-dn 32
dialplan-pattern 1 972....... extension-length 4
access-code pri 9 direct-inward-dial
!
dial-peer voice 100 pots
service mgcpapp
incoming called-number .
port 0/0/1:23
!
dial-peer voice 101 pots
service mgcpapp
incoming called-number .
port 0/0/0:23
!
dial-peer voice 200 pots
description ** Primary - Incoming Call Dial Peer **
incoming called-number .
direct-inward-dial
port 0/0/0:23
!
dial-peer voice 201 pots
description ** Secondary - Incoming Call Dial Peer **
incoming called-number .
direct-inward-dial
port 0/0/1:23
!
dial-peer voice 208 pots
description ** Primary - 10 Digit Dial Peer **
destination-pattern 9[2-9]..[2-9]......
port 0/0/0:23
!
dial-peer voice 209 pots
description ** Secondary - 10 Digit Dial Peer **
preference 1
destination-pattern 9[2-9]..[2-9]......
port 0/0/1:23
When I create ACLs to block traffic from the phone to the CM and from CM and the MGCP gateway, both the Phone registers to the SRST gateway and MGCP falls back.
I can make outbound calls fine. When I try an inbound call, I receive dialtone after making the call.
Unfortunately I do not have the debugs to show you but the 'show ccm-manager fallback' showed that it was Enabled/ON.
Any ideas why I am receiving dialtone after making an incoming call? Im sure some of that config is not needed but dont' know if its necessarily the problem, for example: the 'access-code pri' command...not needed but is it causing a problem?
