07-30-2009 12:27 PM - edited 03-15-2019 07:09 PM
When I`ve used TAPS in CCM4.X before you have to use a CRS server on the CCM server however how do you install, use TAPS with 6.x Do you need a UCC server or can TAPS be installed in CUCM 6.X? does it need any more SW other then CUCM? thanks
Solved! Go to Solution.
07-30-2009 12:56 PM
Hi IPT,
I always hate being the bearer of bad news, but, you are correct :( TAPS will require a seperate CRS/IPCC server in this case. Of course this used to be able to be a built-in function using a co-resident CCM/CRS build but no longer now that CUCM 6.x and 7.x are using Linux. This box will have to be purchased.
Here is some of the relevant config info.
Starting @ Page 369;
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/5_2_3/bat.pdf
Hope this helps!
Rob
07-30-2009 12:56 PM
Hi IPT,
I always hate being the bearer of bad news, but, you are correct :( TAPS will require a seperate CRS/IPCC server in this case. Of course this used to be able to be a built-in function using a co-resident CCM/CRS build but no longer now that CUCM 6.x and 7.x are using Linux. This box will have to be purchased.
Here is some of the relevant config info.
Starting @ Page 369;
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/5_2_3/bat.pdf
Hope this helps!
Rob
07-30-2009 01:14 PM
Or if you are "creative" you can build UCCX in VMware (or MS Virtual machine). Works good!
07-31-2009 12:09 AM
thanks for the reponses- thats what I thought regarding a off box UCCX. My concern was that when I asked our SI to confirm that a UCCX 7.x can prvide us with TAPS as well as being a Call Centre for another project I got a look of confusion- either they have never used TAPS via the UCCX or I was talking rubbish but according to your replies I`m not .
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide