UCM 9.0, KEM and Extension Mobility...!?

[s.angelmahr]

Hi,

on UCM 9.0 i cannot configure a KEM Module on the User Device Profil for a 9951 phone.

So the user can't configure the SD Buttons on the KEM.

On the according Phone Button Template i've configured the "Add a new SD" buttons, but the User only see's Button 1 to 5 on the CCMUserpage.

What am i doing wrong?

Regards,

Sven

[s.angelmahr]

Same on version 8.6, just checked at an other customer...

[s.angelmahr]

It's just a fucked up admin interface.

After going to "Bulk Admin" --> "UDP" --> "Update UDP" --> "Query"

"Device Type" --> "contains" --> "9951" --> Find --> Next

i can select Module1 and Module2, check "Run immediately" and thats it. I still can't see the moduls on the UDP config page, but the user can add the speed dials on ccmuser.

Thanks for listening!