09-20-2008 11:54 AM - edited 03-15-2019 01:26 PM
ws-svc-cmm with ws-svc-cmm-6E1 3 module running with IOS 12.2(ZP4) , i were try to upgrade firmware of FPGA,EPLD B from version 0XA to 0X2 before move on to 12.3(8XY) but after type command
CMM01#test fpga downgrade 1
and reload
found error message
!
Start FPGA download slot 2...
Error: File open failed! handler -1
FPGA download slot 2 can't be done!
%ALIGN-1-FATAL: Illegal access to a low address
addr=0x14, pc=0x609C0304, ra=0x609C02E8, sp=0x64A6D540
Unexpected exception, CPU signal 10, PC = 0x609C0304
-Traceback= 609C0304 609BD45C 600F9810 600F97FC
$0 : 00000000, AT : 614F0000, v0 : 00000001, v1 : 00000014
a0 : 00000014, a1 : 649A76F0, a2 : 62B65B94, a3 : 00000000
t0 : 62B65B54, t1 : 62B65B50, t2 : 62B65B4C, t3 : 62B65B48
t4 : 62B65B44, t5 : 62B65B40, t6 : 62B65B3C, t7 : 62B65B38
s0 : 00000001, s1 : 00000004, s2 : 00000000, s3 : 00000000
s4 : 00000000, s5 : 00000049, s6 : 00000000, s7 : 62B60000
t8 : 62B65B94, t9 : 00000000, k0 : 3040D001, k1 : 2042E4B3
gp : 6141BCC0, sp : 64A6D540, s8 : 00000000, ra : 609C02E8
EPC : 609C0304, ErrorEPC : FFFFFFFF, SREG : 3400FF03
Cause 0000000C (Code 0x3): TLB (store) exception
Writing crashinfo to bootflash:crashinfo_19930301-000038
=== Flushing messages (07:00:38 GMT+7 Mon Mar 1 1993) ===
Buffered messages:
*Mar 1 00:00:06.047: jagger_cmq_init_pmc_cmq_device: Invalid dHdl
*Mar 1 00:00:06.047: jagger_cmq_init_pmc_cmq_device: Invalid dHdl
*Mar 1 00:00:06.471: jagger_cmq_init_pmc_cmq_device: Invalid dHdl
*Mar 1 00:00:06.471: jagger_cmq_init_pmc_cmq_device: Invalid dHdl
*Mar 1 07:00:23.139: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 1 07:00:23.388: %SYS-5-RESTART: System restarted --
*Mar 1 00:00:23.392: Slot 1, 6T1/6E1, Begin dsp dnld ...
*Mar 1 00:00:23.400: Slot 2, 6T1/6E1, Begin dsp dnld ...
*Mar 1 00:00:23.408: Slot 3, 6T1/6E1, Begin dsp dnld ...
*Mar 1 00:00:29.844: Dnld. Copy Err, dsp 0 core 0 !
*Mar 1 00:00:29.844: Dnld. Copy Err, dsp 0 core 0 !
*Mar 1 00:00:29.844: Dnld. Copy Err, dsp 0 core 0 !
*Mar 1 00:00:29.844: Dnld. Copy Err, dsp 0 core 0 !
*Mar 1 00:00:30.016: Dnld. Copy Err, dsp 0 core 1 !
*Mar 1 00:00:30.016: Dnld. Copy Err, dsp 0 core 1 !
*Mar 1 00:00:30.016: Dnld. Copy Err, dsp 0 core 1 !
*Mar 1 00:00:30.016: Dnld. Copy Err, dsp 0 core 1 !
*Mar 1 00:00:30.196: Dnld. Copy Err, dsp 0 core 2 !
*Mar 1 00:00:30.196: Dnld. Copy Err, dsp 0 core 2 !
*Mar 1 00:00:30.196: Dnld. Copy Err, dsp 0 core 2 !
*Mar 1 00:00:30.196: Dnld. Copy Err, dsp 0 core 2 !
After above error it will prompt to ROMON state, do i have any chance or how to recover this module.
09-20-2008 12:10 PM
best to open a TAC case and submit the crashinfo file or if possible, a "sh stack"
you can troubleshoot the crash with
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl
usually if I recall correctly, "illegal access to low address" is bad HW.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: