Hi,
We are experiencing issues when we place a call to the PSTN and it is redirected to a answering machine, for example if I place a call to my cell phone and it is powered off normally it will be answered by the voice mail of my celular company, but in this case whe have two strange behaviors:
1.- the call keeps ringing like my cell phone were available.
2.- the call is connected but we are experiencing something like one way audio, we cannot hear audio from the voicemail, but checking my voice mail on my cell phone I realized that I am able to leave a message.
This two issues occours randomly and for both home answering machines and cell phones voicemails, with regular calls we have no problems.
we have:
CUCM 9.1
GW 3900 - 15.1 (4) M7
The GW is connected with the CUCM via SIP, and with the PSTN with E1 R2.
Phone > CUCM > SIP > Gateway > E1 R2 > PSTN
Here is part of the configuration that I think could be relevant:
!
!
voice call convert-discpi-to-prog
!
voice service voip
no ip address trusted authenticate
allow-connections sip to sip
signaling forward unconditional
sip
bind control source-interface Loopback0
bind media source-interface Loopback0
rel1xx disable
min-se 360 session-expires 360
header-passing
!
voice rtp send-recv
!
controller E1 3/1
framing NO-CRC4
line-termination 75-ohm
ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
cas-custom 0
country telmex
release-guard-time 2
disconnect-tone
category 2
answer-signal group-b 1
ani-digits min 4 max 20
answer-guard-time 500
timer interdigit incoming 1000
groupa-callerid-end
dtmf timer inter-digit 250
description E1 para PSTN
!
voice-port 3/1:0
cptone MX
!
dial-peer voice 401 pots
description ** LLAMADAS A CELULAR LOCAL y LD**
preference 1
destination-pattern 9044..........
port 3/1:0
forward-digits 13
no register e164
I hope you can help me.
Regards.
