04-17-2013 11:23 AM - edited 03-16-2019 04:51 PM
I need the stcapp feature speed-dial disabled, so I disabled this feature with command "no stcapp feature speed-dial" but always that this device is reloaded this feature return to default mode and it's enable again. How I fix it?
Solved! Go to Solution.
04-17-2013 12:22 PM
Hi Tiago,
This is expected behavior if you have the the "ccm-manager config" command configured. You can either disable the command or disable the speed dial feature after every reload or SCCP process restart.
You can refer to:
http://www.cisco.com/en/US/docs/ios/voice/command/reference/vr_c4.html#wp1105076
Regards,
Tere.
If you find this post helpful, please rate!
04-17-2013 12:22 PM
Hi Tiago,
This is expected behavior if you have the the "ccm-manager config" command configured. You can either disable the command or disable the speed dial feature after every reload or SCCP process restart.
You can refer to:
http://www.cisco.com/en/US/docs/ios/voice/command/reference/vr_c4.html#wp1105076
Regards,
Tere.
If you find this post helpful, please rate!
04-17-2013 01:29 PM
Thanks Tere,
Really the command "ccm-manager config server x.x.x.x" was setted, I'm working with SCCP so after that I remove it this issue was fixed.
Regards,
Tiago
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: