VIC card for 2811 router

[miroslavpetkovic]

Dear

I have problem with VIC2B-S/T TE card (for ISDN BRI) which I try to connect to 2811 voice router with callmanager express.

IOS version is c2800nm-advipservicesk9-mz.124-20.T.bin and Cisco Unified Communications Manager Express 7.0(0) version.

In sh inventory I can't find VIC2B-S/T TE card, and appears error:

gt96k_mbrd_wic_interrupts_handle: Unexpected WIC intr, wic int status 0x3

in console.

Maybe card is unsupported.

Which VIC card is supported for cisco 2811 voice router?

BR,

Miroslav

[paolo bevilacqua]

You may not have the card that you think, or it may be damaged. Also check, "show diag".

[miroslavpetkovic]

Thank you.

This is part of the output of sh diag. Card is VIC-2BRI-S/T-TE=.

WIC Slot 2:

TE BRI Voice daughter card (2 port)

WIC module not supported/disabled in this slot

Hardware revision 1.0 Board revision G0

Serial number 33728859 Part number 800-03803-03

FRU Part Number VIC-2BRI-S/T-TE=

Test history 0x0 RMA number 00-00-00

Connector type Wan Module

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 14 01 00 02 02 A9 5B 50 0E DB 03 00 00 00 00

0x30: 80 00 00 00 05 06 23 01 FF FF FF FF FF FF FF FF

But my router doen't recognize this card. I can't find it in sh inventory.

Is this card supported for 2811?

BR,

Miroslav

[paolo bevilacqua]

You have a VIC- card that is not supported on the 2811. You need a VIC2- card. See:

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

[miroslavpetkovic]

Which VIC2 card I can use, similar as VIC2-2BRI-NT/TE, but without network termination (NT), for European standrar use?

BR,

Miroslav

[paolo bevilacqua · Accepted solution]

Always use VIC2-2BRI-NT/TE.

The NT feature is optional, default is TE.