10-30-2014 12:18 AM - edited 03-17-2019 12:44 AM
Hi Everyone
I am using VIC 2 FXO card and Video IP Phone.
I want to configure fxo port like if any call comes over fxo port and land on video ip phone (voice only).
Thanks
Maninder
10-30-2014 12:44 AM
Hi Maninder
Just some questions.
Which model of router end version of IOS are you using.
What model of video phone do you have?
In case of non cisco video phone, which signaling protocol is this phone able to use?
Last.. are you in CME or CUCM deployment (please mention the version)
Let us know
Thanks
Regards
Carlo
10-30-2014 02:23 AM
Hi Carlo
Router model is 2900
IOS 15.3(2) T
Video Phone is cp9971
I am in CME
Regards
Maninder
10-30-2014 11:13 AM
You can use connection plar for this
10-30-2014 11:16 PM
Hi Javelkur
I am expecting complete steps of configuration. Pls send complete configuration.
10-30-2014 11:40 PM
sh your config
and I will do
11-01-2014 01:34 PM
Hi,
you can do it by the adding the below command under voice-port
connection plar opx dx650-extension
HTH
Anas
don't forget to rate the helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide