10-11-2012 01:38 AM - edited 03-01-2019 05:37 PM
Hello, sorry because of my bad English at first,
I have a problem with my IPv6 ACL, IPv6 Class-map or IOS I'm not sure so I'm asking you.
I have one 1721 router with one Ethernet and one FastEthernet interface, on Fa interface is 3 subinterfaces, and Eth interface is connected to 10 Mbps link to another 1721 router. I'm working on QoS for VoIPv6. My softphone emulator address is FEC2::1/64.
This is my configuration:
!
class-map match-any v6
match access-group name v6
!
policy-map v6
class v6
set ip dscp ef
!
ipv6 access-list v6 permit FEC2::/64 any
!
Question is, why is output of command show policy-map interface Fa0/0 showing that not a single one packet of IPv6 is not beeing marked:
R1#sho policy-map interface fa0
FastEthernet0
Service-policy input: v6
Class-map: v6 (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: access-group name v6
0 packets, 0 bytes
5 minute rate 0 bps
QoS Set
ip dscp ef
Packets marked 0
Class-map: class-default (match-any)
92 packets, 9134 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
This exact configuration, with IPv4 is working fine. My IOS version is c1700-y-mz.122-11.T11.bin
If IOS version is too old, can you tell my what version will work so I can purchase it?
Thanks
10-11-2012 07:57 AM
Do you try to change the prefix-list?
10-11-2012 09:49 AM
If you are thinking of IPv6 prefix I tried everything. From /128 for single host to /64, nothing works.
10-16-2012 06:35 AM
Anyone?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide