IPV6 Command is not active or works

[ShaheenAhmed1541]

I cant configure IPv6 in the router. The command IPv6 is not available! See the version screen shot

Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 15.1(1)T, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Mon 22-Mar-10 00:27 by prod_rel_team

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

R3 uptime is 5 minutes

System returned to ROM by reload at 01:32:28 UTC Thu Jan 1 1970

System image file is "flash:c1841-ipbase-mz.151-1.T.bin"

Last reload type: Normal Reload

Cisco 1841 (revision 7.0) with 117760K/13312K bytes of memory.

Processor board ID FCZ121814UA

2 FastEthernet interfaces

2 Low-speed serial(sync/async) interfaces

DRAM configuration is 64 bits wide with parity disabled.

191K bytes of NVRAM.

31808K bytes of ATA CompactFlash (Read/Write)

License Info:

License UDI:

-------------------------------------------------

Device#   PID                   SN

-------------------------------------------------

*0        CISCO1841             FCZ121814UA

Any idea what could be the problem?

[luis_cordova · Accepted solution]

Hi @ShaheenAhmed1541 

The problem lies in the type of license, because with IPBASE the function is not available.

Chek this:

https://cfn.cloudapps.cisco.com/ITDIT/CFN/jsp/SearchBySoftware.jsp

IPBASE

ADVANCE IP SERVICES

ADVANCE ENTERPRISE SERVICES

Regards

[ShaheenAhmed1541]

Many thanks. I kind of guessed the issue was with the ios, so possibly licensing issue. Many thanks for clearing this with me @luis_cordova  

[luis_cordova]

Hi @ShaheenAhmed1541 

Remember to mark the correct answers as solved, because they help other users with similar doubts.

Regards