IPv6 & IP SLA config

[harris-sprint]

Hi Team,

I'm looking for IPv6 IP SLA config for my c3845. The plan is to ping the remote site and if it timeout, then this will generate syslog or SNMP trap.

I checked " Configuring ICMP Echo Operations" Cisco document and all config for IPv4 not Ipv6. I tried diffrent IOS ie.. c3845-adventerprisek9-mz.151-4.M.bin and still not seeing IPv6 x:x:x:: under icmp-echo.

Any idea?

Thanks

[rati jokhadze]

hm, maybe you need

ping ipv6 xxx:xx:xx:xx:x  ?

[harris-sprint]

Need someting automatic to check/ping every 5 second, and if unable to ping the remote site then this will generate trap to the server either (SNMP or Syslog).

I found some config in the link below. However looking to see if someone know what IOS it support in the C3800. Itried

c3845-adventerprisek9-mz.124-24.T2.bin & c3845-adventerprisek9-mz.151-4.M. and no luck.

Thanks

ip sla 1
 icmp-echo 2001::214:A8FF:FE7A:ED70
ip sla schedule 1 start-time now

 
 source:
 
 http://docwiki.cisco.com/wiki/IOS_IP_SLAs_for_IPv6_White_Paper#Configuration_Examples

[Laurent Aubert]

Hi,

It’s not enabled by default. Please use the ip sla logging trap command. Please refer to the link below for usage guidelines:

http://www.cisco.com/en/US/docs/ios/ipsla/command/reference/sla_02.html#wp1052104

HTH

Laurent.

[harris-sprint]

Thank Laurent, do you know which code/feature set to use with c3800?

as I tried 3 codes and when i enable IP SLA see below I did not see v6 choice, I'm looking for a code that will show up IPv6 address like v4 address below:

AN1212#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

AN1212(config)#ip sla 1

AN1212(config-ip-sla)#icmp-echo ?

  Hostname or A.B.C.D  Destination IP address or hostname, broadcast disallowed

Thanks for the help.

Maz

[Laurent Aubert · Accepted solution]

FN says it’s supported with 15.1(4)M and I verified it as well on a router running 15.1(4)M1:

R1(config)#ip sla 1

R1(config-ip-sla)#icmp-echo ?

  Hostname or X:X:X:X::X

  Hostname or A.B.C.D  Destination IPv6/IP address or hostname

You should open a SR with the TAC as something is definitely going wrong in your setup

Thanks,

Laurent

[harris-sprint]

Thanks Laurent,

15.1(4)M1 with adventerprisek9- feture set supported IPv6 IP SLA. Need of course to enable IPv6 and assign IPv6 address on the interface to see the

R1(config-ip-sla)#icmp-echo ?

  Hostname or X:X:X:X::X

Thanks again,

Maz

[Imtiyaz95]

Hello everyone, i'm using c7200-adventerprisek9-mz.152-4.M7.image and it does not support ipv6 SLA. Which ios of C7200 support the SLA for ipv6?

[mari22]

I found some config in the link below. However looking to see if someone know what IOS it support in the C3800. Itried    https://xender.pro/ https://discord.software/ https://omegle.onl/