Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an environment where my authenticator is an IOS router and my supplicant an IoT endpoint. I'm trying to do EAP-TLS to authenticate the endpoint.The authenticator will send the first EAP-Request to get the supplicant Identity with an EAP Id ...
Hi,Is there a way to configure ISE not to send the full certificate chain during the Server Hello phase ?My supplicant is a sensor with very limited memory and can't store a full certificate chain. Thanks.
Hi,
I would like to leverage the Mobile App to upload the bootstrap config for a router which use 4g as a backhaul network.
Challenge is the 4g cellular interface configuration requires some interactivity:
IR800#cellular 0 lte profile create 1 jas...
Based on RFC 4448, an Ethernet PW can operate in two different modes:- Raw mode or VC Type 5- Tagged mode or VC Type 4The main difference is in raw mode the service delimiter (SD) tag (outer tag) must not be propagated and in tagged mode the service...
HiI understand all of this. My question is if both ISE and the client are sharing the same root CA, I must import it so ISE can authenticate the client which sends only it's identity certificate. Can I also configure ISE at the same time not to send ...
If I use an Intermediate CA to issue the certs for my clients, do I need to import both the intermediate and the root ca in ISE or just the Intermediate CA ?As ISE certificate was issued by the Root, I can't import it so ISE will only send its certif...
HI,Unfortunately, this is not an acceptable solution. The same Root CA will also issue the certificates for the endpoints.Are you saying there Is no way to change this behavior ?Thanks,
As the layer 2 and 3 headers don't change, I'm not expecting a fair load-sharing over the links member of the bundle. L3 load-balancing may be a better approach here.My 2 ctsLaurent.
Hi Rajeev,Yes this platform supports IPv6. Release choice and performance impact first depends on which IPv6 feature you want to deploy and your environment.You should start with the Feature Navigator to find the right release and then work with you...
