Does anyone have any experience setting up NAT64 using Google DNS64?
I have just started using IPv6 and am unable to access IPV4 network over this obviously. But I am having issues configuring NAT64, I m wanting to use stateful (unless I am unable to do so) to preserve IPv4 addresses and use Googles DNS64 PREFIX 64:ff9b::/96
.
I have nat64 enabled on the interface that goes to the internet and on the interface to the clients.
The connection to the internet is dual stacked. I cannot find a clear answer on how to configure this in a cisco ASR. When I try using nat64 prefix stateful 64:ff9b::/96 i get the following %NAT64: Cannot use the well-known prefix 64:FF9B::/96 for a stateful prefix
Any help would be greatly appreciated.