Static NAT between IPV6 and private IPv4

[Learner09]

Hello experts, Please advise on how I can configure cisco router to perform static nat between IPv6 address and private IPv4 address, so that server inside the network can be accessed from internet using the IPv6 address. I read about NAT-PT does this, but my router doesn't support any commands starting with 'ipv6 nat' 

[Harold Ritter]

Hi @Learner09 ,

Here's a document giving a good example on how to configure static nat64. Do not hesitate to let us know if you have any question.

https://community.cisco.com/t5/networking-knowledge-base/ipv6-stateful-nat64-configuration-example/ta-p/3124475

Regards,