Hey,
I'm running Flexible Cross-connect service over EVPN and i'm trying to establish CFM CCM over it.
I'm running it in a lab, and i'm getting "configuration errors present" in the "show ethernet cfm services" but i can't tell where is the error.
My domain is configured as follows:
ethernet cfm
domain Mark_BD level 1 id null
service Mark_DDD flexible-xconnect vlan-aware evi 100 id string hey
continuity-check interval 1s
mep crosscheck
mep-id 88
!
The configuration of the local MEP & AC attached to the FXC is:
interface HundredGigE0/0/1/0.666 l2transport
encapsulation dot1q 1999
rewrite ingress tag translate 1-to-1 dot1q 1365 symmetric
ethernet cfm
mep domain Mark_BD service Mark_DDD mep-id 6839
!
The FXC is up:
Flexible XConnect Service Segment
Name ST Type Description ST
------------------------- ----------------------------------
evi:100 UP AC: Hu0/0/1/0.666 UP
PW: EVPN 100,66.66.66.66 UP
But when initiating the show on "ethernet cfm services domain <domain_name> service <service_name>", I'm getting (1 disabled)
RP/0/RP0/CPU0:cisco-ncs001(config-cfm-dmn)#do show ethernet cfm services domain Mark_BD service Mark_DDD
Sun Jun 30 02:28:10.274 EST
Summary for Domain Mark_BD (level 1), Service Mark_DDD
=============================================================================
Domain MIB index: 6, Service MIB index: 5
Domain ID: NULL, Service ID: String: hey
Service configured on Flexible cross-connect (VLAN-aware) with EVI 100
CCM interval: 1s
!! Configuration errors present
Local MEPs: 1 total: 0 operational (0 with errors), 1 disabled
Peer MEPs: 0 total
MIPs: 0, MIP creation rule: none
I cannot tell where is the configuration error. The commit passed but the local MEP doesn't get installed into Datapath. Could it be something arbitrary that i missed ?
Thanks in advance !