cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
988
Views
0
Helpful
1
Replies

auto-cost reference-bandwidth

paulo.lobato
Level 1
Level 1

Hello everyone, next days I'll have a MW in order to adjust some OSPF parameteres in a big network with ASR9K IOS-XR and I have the following doubt:

If I configure the command "auto-cost reference-bandwidth" globally is it applied for all VRFs or I have to configure for each VRF where I have OSPF instances, that I want to change the cost behavior?

What is the recommendation? Globally or by VRFs?

Regards,

Paulo

1 Reply 1

always use per VRF as reference BW can vary w.r.t. interfaces (in-turns VRFs)