cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
636
Views
0
Helpful
1
Replies
Beginner

auto-cost reference-bandwidth

Hello everyone, next days I'll have a MW in order to adjust some OSPF parameteres in a big network with ASR9K IOS-XR and I have the following doubt:

If I configure the command "auto-cost reference-bandwidth" globally is it applied for all VRFs or I have to configure for each VRF where I have OSPF instances, that I want to change the cost behavior?

What is the recommendation? Globally or by VRFs?

Regards,

Paulo

Everyone's tags (4)
1 REPLY 1
Rising star

always use per VRF as

always use per VRF as reference BW can vary w.r.t. interfaces (in-turns VRFs)

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards
This widget could not be displayed.