Hi,
I am trying to set up MC-LAG in ASR920. The problem is that the traffic comes back to primary device when primary link returns live. I like to set this up in non-revertive mode and its not working. Can some one please check the config and advise me whats wrong?
Thanks ...
Rajan
++++++++++++++++++++++++++relevant configuraion++++++++++
redundancy
interchassis group 10
member ip 10.72.4.1
backbone interface TenGigabitEthernet0/0/1
mlacp node-id 0
interface Loopback0
ip address 10.72.4.2 255.255.255.255
interface Port-channel10
mtu 9216
no ip address
lacp failover non-revertive
lacp fast-switchover
lacp max-bundle 1
mlacp interchassis group 10
service instance 10 ethernet
encapsulation dot1q 931
rewrite ingress tag pop 1 symmetric
bridge-domain 931
interface TenGigabitEthernet0/0/1
mtu 9216
ip address 10.150.0.2 255.255.255.252
mpls ip
interface TenGigabitEthernet0/0/11
mtu 9216
no ip address
negotiation auto
cdp enable
channel-group 10 mode active
interface BDI931
ip address 10.11.11.3 255.255.255.248
+++++++++++++++++++++++++++++++++
redundancy
interchassis group 10
member ip 10.72.4.2
backbone interface TenGigabitEthernet0/0/1
mlacp node-id 1
interface Loopback0
ip address 10.72.4.1 255.255.255.255
interface Port-channel10
mtu 9216
no ip address
lacp failover non-revertive
lacp fast-switchover
lacp max-bundle 1
mlacp interchassis group 10
service instance 10 ethernet
encapsulation dot1q 931
rewrite ingress tag pop 1 symmetric
bridge-domain 931
interface TenGigabitEthernet0/0/1
mtu 9216
ip address 10.150.0.1 255.255.255.252
mpls ip
interface TenGigabitEthernet0/0/11
mtu 9216
no ip address
negotiation auto
cdp enable
channel-group 10 mode active
interface BDI931
ip address 10.11.11.2 255.255.255.248
