I understand that unless the packets are pushed through CPU, the stats will not show up in a "show int vlan <xxxx>" command output as show below. Others have posted similar inquiries on this website with no real satisfactory solution. Every other switch I have ever dealt with(6500, 4948, 3560, 3750, 2900 series, etc, etc, etc.) have not had this issue. Is there a way to force "routed"/layer-3 packets to traverse the CPU in order to get the SVI stats needed? It seems strange that one switch would behave this way while all others do what we need them to do in order to report traffic correctly.
IntroductionFeature EnablementMirroring explainedConfiguration & VerificationLimitations
Prior to Cisco IOS XR Software Release 7.1.2, XR dual RP devices did not support file mirroring from active RP to standby RP. Administrators ...
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...
When I run the command 'sh controllers fabric fia q-depth location 0/0/CPU0' or any 0/X/CPU0 and see the following, what exactly does it mean? RP/0/RSP0/CPU0:Router#sh controllers fabric fia q-depth location 0/0/CPU0********** FIA-0 **********Categor...
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.