Does anybody know how to configure properly "bpdu relay" feature between two ME3600 as MPLS PE routers?
Problem is: Both should be configured with MST and "l2protocol peer stp" for untagged frames on EFP toward access switches and additionaly thay need xconnect between them (special PW between PE for untagged frames). But problem is they don't see each other this way.Consequence is that access switches doesn't stp block any link toward PEs.
I know I can use "l2protocol forward stp" instead of peer but then PE doesn't consume BPDUs and hence there is no "mac address withdrawal" in case TCN comes from access network to PE.
show controller npu voq-usage interface all instance all location all
NPU/CORE/VOQ Base information + NPU to port mapping
show platform cpu
Operational Status of all CPU based cards
show platform secur...
Crosswork Cloud - Crosswork Trust Insights FAQ
Cisco Crosswork Trust Insights is a Cloud-hosted Software as a Service platform that helps to track, analyze, and prove hardware and software components running in your network. Trust Insights works w...
Some of you may have watched the session at Cisco’s first all-digital Cisco Live and I hope you found it helpful. This is the first in a series of companion blogs that will later cover in more detail the topics discussed in the session today. ...
CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot.
One can also perform the operation manually, like a "turboboot" for classic XR in this facinity.
this procedure will wipe out the complete system and install a...
Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the...