I try to configure my ME3400 E series switch according to the guide line /manual , do exactly what was told in the manual line by line.
MainSwitch>enable
MainSwitch# configure terminal
MainSwitch(config)# pppoe intermediate-agent
the response that I got is
MainSwitch(config)# pppoe intermediate-agent
^
% Invalid input detected at '^' marker.
MainSwitch(config)#
It seem pppoe is not in the list of command , as when type pppoe than Tab key nothing show or type "?" at prompt there is no pppoe in the list .
Who can advise why?