11-22-2013 09:42 AM
I'm trying to configure a VLan interface on my ME2600X (for inband management), but the switch won't accept the command.
What am I missing? I need a way to combine layer-2 services and a management vlan on the same dot1q trunk into the ME2600X.
Geir Jensen
11-29-2013 02:28 AM
Hello Geir,
You can use service instances e.g.:
interface GigabitEthernet0/3
switchport trunk allowed vlan none
switchport mode trunk
dampening
mtu 9100
load-interval 30
media-type rj45
service instance 5 ethernet
description Management VLAN
encapsulation dot1q 5
rewrite ingress tag pop 1 symmetric
bridge-domain 5 – this will pop up message:
Bridge-domain 5 created
VLAN 5 does not exist, creating vlan
!
interface Vlan5
description Management VLAN
ip address 10.0.0.1 255.255.255.0
ip access-group MNGT-ACL in
end
adam
12-06-2013 11:07 AM
It turns out that the ME2600X doesn't support Vlan interfaces, instead you have to configure a BDI interface.
Something like this:
Interface GigabitEthernet0/1
service instance 1 ethernet
encapsulation dot1q 10
rewrite ingress tag pop 1 symmetric
bridge-domain 310 split-horizon
!
interface BDI 310
Ip address 10.0.0.1 255.255.255.0
!
Geir
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide