I have an ASR1001x and want to enable the "neighbor x.x.x.x send-label" command, but it's not available to me. I have an IPB license, but I thought since licensing seems to be honor-based that the command would be available on all flavors even without a license present. Is this the case of will the command become unavailable if the correct license is not present?
Thanks in advance!
XXXXXX(config-router)#address-family ipv6 ?
flowspec Address Family modifier
multicast Address Family modifier
mvpn Address Family modifier
unicast Address Family modifier
vrf Specify parameters for a VPN Routing/Forwarding instance
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...