I understand that there are two types of EoMPLS, VLAN based (VC type 4) and port based (VC type 5). However, I am a little confused on the configuration and the show command output on the router.
I tried to configure port based EoMPLS using below configuration between the PEs:
service instance 10 eth
encap dot1q 10
rewrite ingress tag pop 1 sym
xconnect PE2 10 encap mpls
the output of show mpls l2transport vc 10 det is below:
CGR-NPE-01#sh mpls l2transport vc
Local intf Local circuit Dest address VC ID Status
Gi2/17 Eth VLAN 888 10.1.0.15 888 UP
Sorry this is incorrect post that I created. I could not find a way to delete it. Please ignore this. Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: