Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I understand that there are two types of EoMPLS, VLAN based (VC type 4) and port based (VC type 5). However, I am a little confused on the configuration and the show command output on the router.First TestI tried to configure port based EoM...
Hi All,I understand that there are two types of EoMPLS, VLAN based (VC type 4) and port based (VC type 5). However, I am a little confused on the configuration and the show command output on the router.I tried to configure port based EoMPLS using bel...
Hi All,I have read ES+ configuration guide regarding configuring REP. Its stated that we can configure REP on a bridge domainExamples This example shows how to configure REP over EVC using bridge-domain. Router# enable
Router# configure terminal R...
Hi,I have a question regarding ASR1K memory. I usually use "show proc mem" to see how much memory is used by the router. Below is the output from my ASR1KASR-1K#sh proc memProcessor Pool Total: 724922940 Used: 258733288 Free: 466189652 lsmpi_io Po...
Hi All,I am using ASR1004 for address translation for my subscribers. I have a problem that nat translation session is already a half (1 million) of what ASR1K ESP20 limitation (2 million session). Below is the output of "show ip nat statistics":Tota...
Hi Xander & All,
I have issue with IPoE and loadbalancing result when using RP based IPoE session. As mentioned above, load balance is based on dst IP so that the traffic only flowing over 1 interface, thus making PQOS working correct since the pol...
Hi Ricardo,Yes my module 1 is ES+ module, otherwise I can not configure EVC right? or there are other modules that can support EVC?below is my show module:KGD-NPE-01#sh module Mod Ports Card Type Model Serial...
