Hi All,
I understand that there are two types of EoMPLS, VLAN based (VC type 4) and port based (VC type 5). However, I am a little confused on the configuration and the show command output on the router.
I tried to configure port based EoMPLS using below configuration between the PEs:
int gig0/1
service instance 10 eth
encap dot1q 10
rewrite ingress tag pop 1 sym
xconnect PE2 10 encap mpls
the output of show mpls l2transport vc 10 det is below:
CGR-NPE-01#sh mpls l2transport vc
Local intf Local circuit Dest address VC ID Status
Gi2/17 Eth VLAN 888 10.1.0.15 888 UP