Hello,
I'm currently deploying some ISR 1900 as MPLS hand off with xconnect and would like to do testing to make sure that the configuration is correct, but I can not find a way to force my customer facing interface in a up state without them plugging something in.
Se below for configuration
#sh xconnect all
Legend: XC ST=Xconnect State S1=Segment1 State S2=Segment2 State
UP=Up DN=Down AD=Admin Down IA=Inactive
SB=Standby RV=Recovering NH=No Hardware
XC ST Segment 1 S1 Segment 2 S2
------+---------------------------------+--+---------------------------------+--
DN ac Gi0/1(Ethernet) DN mpls x.x.x.x:10000 DN
interface GigabitEthernet0/1
description "Customer interface"
no ip address
duplex auto
speed auto
xconnect x.x.x.x 10000 pw-class ETH-PW
end
And I would like to force it up so I can verify that configuration and that the eompls is working?
I tried the "loopback mac/driver" command under interface, but saw no reaction from the box.
Software version: c1900-universalk9-mz.SPA.151-4.M4.bin
