Hi,
I am trying to export host routes from a connected network from one VRF to multiple other VRFs. This is to allow the leaking specific host routes for management purposes. However, I suspect that the /32 host route(s) actually need to be present in the management VRF so the RTs are added accordingly, rather than just specified in the match clause of the MGMT VRF export map.
Ideally here, I only want to export 10.111.111.254/32 from the connected network 10.111.111.0/24 in the MGMT VRF. The only way around this I can see it to move 10.111.111.0/24 behind another device, and add specific host route(s) within the MGMT VRF for the 10.111.111.X/32 host routes (which are redistributed into the MGMT VRF), using the additional device as the next-hop.
ip vrf MGMT
rd 1:1
export map MGMT-EXPORT-MAP
route-target export 1:1
route-target import 1:1
route-target import 1:1001
!
ip vrf CUST-B
rd 1:2
export map CUSTOMERS-EXPORT-MAP
route-target export 1:2
route-target import 1:2
route-target import 1:1000
!
interface FastEthernet0/0.100
encapsulation dot1Q 100
ip vrf forwarding MGMT
ip address 10.111.111.1 255.255.255.0
!
interface FastEthernet0/0.200
encapsulation dot1Q 101
ip vrf forwarding CUST-B
ip address 10.96.2.1 255.255.254.0
!
router bgp 65000
bgp router-id 1.1.1.1
no bgp default ipv4-unicast
bgp log-neighbor-changes
!
address-family ipv4 vrf CUST-B
redistribute connected
no synchronization
exit-address-family
!
address-family ipv4 vrf MGMT
redistribute connected
no synchronization
exit-address-family
!
ip prefix-list CUSTOMERS seq 5 permit 10.96.2.0/23
!
ip prefix-list ONPREMISE seq 5 permit 10.111.111.0/24
ip prefix-list ONPREMISE seq 10 permit 10.111.111.254/32
!
route-map CUSTOMERS-EXPORT-MAP permit 10
match ip address prefix-list CUSTOMERS
set extcommunity rt 1:1001 additive
!
route-map MGMT-EXPORT-MAP permit 10
match ip address prefix-list ONPREMISE
set extcommunity rt 1:1000 additive
Cheers,
Matt
