I'm trying to only mpls what I need to mpls and nothing else.Here's the idea:interface te1/1ip address x.xmtu 9000...etc..interface te1/1.50encap dot1q 50ip address x.x.x.xmpls ipvrf forwarding VRF2..etc..Mpls only running on te1/1.50 and not te1/1Te...
Hi,I am trying to export host routes from a connected network from one VRF to multiple other VRFs. This is to allow the leaking specific host routes for management purposes. However, I suspect that the /32 host route(s) actually need to be present in...
I am having two Cisco 6509(R01,R02) connecting back to back with MPLS LDP enabled then i try to test VPLS VPN with VLAN AC.R01's LDP Router ID is 111.90.180.8 , R02's LDP Router ID is 111.90.180.9. I got below output:R01#sh mpls l2transport vcLocal i...
I have a question about two companies migration Iusse, Attached scenario should give most of the information.Company A got two router R1 and R2 running EIGRP100 with the service providers 1Company B got R3 Running MPLS BGP with same service provider ...
Does ASR1K support VPLS? or only P2P L2 VPN only? I saw address-family l2vpn is available in BGP. But i can not config VFI on any interface (subinterface or phy).Regards,CT
I am working with ME3600 as PE which does not support policy routing. I am trying to use static routes to achieve the same. The basic setup is standard and works well. MPLS traffic engineering tunnel are set up between PE, as shown here. I’m not show...
Hello ExpertsWith EoMPLS point-to-point link can I put a L2 switch facing the Service provider PE routers on both ends, or does it have to be a L3 router? All the cisco documentations seems to show a router.Reason Im asking is that I have ordered a E...
Hi All, I have a topology with inter_AS as follows:CE_AS1----PE_AS1----P_AS1-----ASBR_AS1<---------->ASBR2_AS2------P_AS2-----PE_AS2-----CE2.The problem faced was that both CEs in each ASes can reach each other but neither the PEs nor the AS...
Those who have dealt with ME3600X switch, can you tell me if I need to purchase the “Advanced Metro IP Access License” in order to run L2/L3 MPLS VPN? The license is $3995 in addition. It is a big cost for us. More specifically, I want to know if the...
DearsWould like your assistance regarding below plzI was wondering how MEF E-line, E-LAN & E-tree services are configured at Cisco ?? What come to my mind is that first we need to have MPLS network then implement these services as below E-line ---...