cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1006
Views
0
Helpful
0
Replies

juniper configuration using NSO Juniper-junos NED issue

Ahmed Elsamahy
Level 1
Level 1

i am working on  a POC with Juniper routers and i am using NSO to configure l2vpn between juniper router and cisco one . i made a netsim network to test service package before adding it to customer NSO server . i am trying to put configuration  like below :-

set interfaces ge-0/3 unit 400 description "test"
set interfaces ge-0/3 unit 400encapsulation vlan-ccc
set interfaces ge-0/3 unit 400 vlan-id 403
set protocols l2circuit neighbor 10.0.0.50 interface ge-/3.403 virtual-circuit-id 32000

 

i found that i cannot type set and cannot type interfaces (interface name )  i must use interfaces interface (interface name) and this is not the right way when configuring juniper router

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: