I have an strange issue with LDP label mapping message. In my lab I have 3 routers. Asr903 and ALU are PE, while asr9922 is P router. I have create xconnect session between asr903 and ALU PE. What I found is asr903 send LDP label mapping message to ALU router over targeted LDP session and that message is included routes learned from asr9922 which is strange. Per my understanding, link LDP will include all routes known by that router which is make sense but targeted LDP which is usually for creating service should not contain dynamic routes learn by that router.
Imagine if we create xconnect session between PE routers then the label mapping message exchange all known routes. It will be a waste of router resources. So, can I make change on asr903 to advertise only connected interface to targeted LDP peer instead of advertise all known routes.
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...
When I run the command 'sh controllers fabric fia q-depth location 0/0/CPU0' or any 0/X/CPU0 and see the following, what exactly does it mean? RP/0/RSP0/CPU0:Router#sh controllers fabric fia q-depth location 0/0/CPU0********** FIA-0 **********Categor...
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.