Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,I have an strange issue with LDP label mapping message. In my lab I have 3 routers. Asr903 and ALU are PE, while asr9922 is P router. I have create xconnect session between asr903 and ALU PE. What I found is asr903 send LDP label mappin...
Hi,I have the topology where ASR9K bundle interface is connected with ASR900 port-channel interface and use BFD signal but the port never come up, below is the detail. ASR9K => IOS-XR 4.3.2, linecard: A9K-MOD80-TR, A9K-MPA-4x10GEASR903 ...
Hi Expert,I have ASR9010 with single incoming interface(GE) and two outgoing interfaces(TenG1 and Bundle-E(TenG2)). the routing/cef/label is configured to forwarding traffic out TenG1. All interfaces are configured with MTU 9194.- When I inject traff...
Hi, ExpertsEquipment: Cisco ASR9922, IOS-XR 4.3.2 Issue: I have problem that my RR do the next-hop-self by using route-policy for client routers, the next-hop is changed as intended but the MPLS label doesn’t changed to reflect the new next-hop.Wha...
Hi guys,Nice video, do you have any tip for implement BFD between ASR903(port-channel) <==> ASR9K (bundle-ethernet). I try and it only good between PO-PO and BE-BE but can not get PO-BE works.Regard,Marit
Hi Rivalino,That's answer the issue i'm faceing, anyway i'm looking into the work around..If we go back one step further, the reason I do this isAN-AN communication: I would like it to take shortest path in golbal-routing instead going back and forth...
