02-27-2004 09:54 AM
Has anyone seen this message:
The bridge-group command is unsupported on the interface:Serial2/0:0.24
when the MPLS feature has been enabled on
the main interface or one of its subinterfaces:Serial2/0:0.2
It used to work in 12.2, but after upgrade to 12.3.5b it's not.
I didn't find anything in the documentation about this problem.
Any help is appreciated.
Solved! Go to Solution.
02-27-2004 10:55 AM
The combination of these two features is unsupported and has caused problems in the past. A check has been implemented by CSCdz75507, which will prevent the configuration of "bridge-group" if MPLS is configured or vice versa.
Hope this helps,
02-27-2004 10:55 AM
The combination of these two features is unsupported and has caused problems in the past. A check has been implemented by CSCdz75507, which will prevent the configuration of "bridge-group" if MPLS is configured or vice versa.
Hope this helps,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide