PBR to choose MPLS TE tunnel

[scytmax_2]

Dear Sir!

I've 2 MPLS TE tunnels from one PE to another PE router. I need to chose Tu0 for voice traffic from my customer and Tu1 for all other this customer traffic.

But I found that PBR are not supported on vrf interfaces (to choose tunnels with SET INTERFACE Tu command).

How can I do it? / or may be I can choose this TE tunnels to solve the problem another way (not PBR)?

Best regards,

Maxim Denisov

[ebreniz]

You can set the Administrative distance with traffic engineering as given below

http://www.cisco.com/en/US/products/sw/iosswrel/ps1612/products_feature_guide09186a0080080a54.html

[sbenfredj]

hello,

if scalability is not an issue,

you can consider playing with the BGP netxhop

while having a global static route to this next hop pointing to the TE tunnel.

rgds,

stephane