Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Cisco Experts and Cisco experienced persons!I'm not receive any definite answer for my question, so I'm repeat this thread:This is a failover problem. We have A/S FWSM failover configuration (ver. 4.0.6 each)This problem suddenly appears when ou...
Dear Cisco Experts and Cisco experienced persons!This is a failover problem. We have A/S FWSM failover configuration (ver. 4.0.6 each)This problem suddenly appears when our ACTIVE unit configuration reached 125K in size. STANDBY can't load this confi...
Dear Sir!Can you tell to me, does the 7600 series of routers supports EoMPLS without shared port adapters (SPAs) and SPA interface processors (SIPs)?I.e. if we have 7606S-RSP720C-R, WS-X6704-10GE ports connected to backbone and WS-X6408A-GBIC with WS...
Dear Sir!A few years ago I buy WS-6509.But the modern version marked as WS-6509-ECan I buy modern modules for my old WS-6509 platform?Best regards,Maxim Denisov
Dear Sir!Because of forgotten console password, I made Cisco IPS Recovery procedure during my IDS-4215 loading. But when I login with default username= cisco, password=cisco, the system asked me to change it's password immediately.Then, when I entere...
Dear Cisco Experts!Now we resolve this problem:don't use '?' sign in your access-list remarks!!!Or FWSM unit can't load properly, but with the errors this post described.With best wishes,Maxim
Magnus,thank You for request of additional information from us. Now we want to provide more detail info (see below).We have two identical WS-C6506 switches with WS-SUP720-3B (s72033_rp-ADVENTERPRISEK9_WAN-M, Version 12.2(33)SXH4) and with one WS-SVC-...
Dear Sir!I'm agree with you as MPLS TE tunnels are opened from PE to PE, so CEF does it work.But if I open this tunnels from P to PE, ONLY ONE of this tunnels are used instead of load-sharing, if traffic go from one source (of site1 of VPN1) to the s...
Dear MichailI have such problem:in my lab I enable IS-IS only on a few of directly connected router interfaces. But IS-IS advertise ALL existing IP networks (from all directly connected interfaces). Then i'm trying to use passive-interface command to...
