09-04-2008 12:09 PM
In case of FRTS when we apply the shaping parameters, for the specific traffic-class and this class is called under the #map-class frame-relay _______ .
What is the terminology used for this tech, it comes under legacy FRTS/MQC-based FRTS??
Sample config:
----------------------------------
class-map TEST
match protocol http
policy-map TEST
class TEST
class class-default
shape average 1024000
shape adaptive 512000
int se1/0
service-policy out TEST
----------------------------------
class-map TEST
match protocol http
policy-map TEST
class TEST
class class-default
shape average 1024000
shape adaptive 512000
map-class frame TEST1
service-policy output TEST
int se0/1
frame-realy interface-dlci 402
class TEST1
----------------------------------
what is the terminology used for them, since both are achieving the same?
Thanks,
Dara
09-05-2008 03:07 AM
Hello Dara,
the first example is Modular QoS based.
In the second one you are using legacy FRTS just to reference to a service-policy that is again Modular QoS.
This second example could be defined an hybrid legacy FRTS/Modular QoS.
I think in the second example you would need frame-rel traffic-shaping command under se0/1 but this is a detail.
Hope to help
Giuseppe
09-05-2008 07:16 AM
Hi,
The router says is terming the second one as GTS.
!
class-map match-all BGP
match protocol HTTP
!
!
policy-map SHAPE
class HTTP
class class-default
shape average 1000000
shape adaptive 512000
!
R2(config-if)#do sh run int se 2/0
Building configuration...
Current configuration : 546 bytes
!
interface Serial2/0
description FRSW
ip address 10.10.24.2 255.255.255.0
encapsulation frame-relay
serial restart-delay 0
no dce-terminal-timing-enable
no clns route-cache
frame-relay class FRTS
frame-relay map ip 10.10.24.4 204 broadcast
no frame-relay inverse-arp
end
R2(config-if)#frame traffic-shaping
Generic traffic shaping commands must be removed before enabling frame-relay
traffic shaping.
AS you can see the interface level frame-relay traffic-shaping isn't accepted when we configure this.
09-06-2008 01:10 AM
Hello Dara,
so the second example could be regarded as a GTS case.
Actually, GTS was available for non FR interfaces with commands like traffic-shape given in interface config mode.
This is interesting I had never used this variation on FR interfaces : or legacy FRTS or Modular QoS.
Best Regards
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide