MPLS

We have two routers in geographically separated regions connecting to two upstream transit providers. The two Internet routers runs ISIS as IGP and I-BGP between each other and other local peers (Customers facing PE routers). We tried to loadshare ou...

Hi,I have a question about the mtu size with mpls.How I set the mtu to support ATOM, VPLS, L3VPN?I found some documents, but for me it is not totally clear.It seems that the 12000 Routers sets automatically the mtu to 1538. The 7606, 7201 and 3750 no...

Hi all,I'm trying to find a way to aggregate the PE routers to a P router. I've read somewhere that this could be done by putting a LAN switch in the middle and run dot1q trunk to the P router. This would cause the PE to PE traffic on the same swit...

I have an issue getting multicast run across an MPLS Backbone, in a test lab. When all PE's are in the same AS all works fine, 4 PE's in a ring topology. If I reconfigure each PE into a seperate AS, .i.e. AS1, AS2, AS3, AS4. Multicast stops working a...

Trying to get Multicast working on MPLS test LAB. The LAB only has 4 PE's built in a ring topology. See BelowAS4-AS3| |AS1-AS2I have a test VRF configured on AS1 and AS3, working fine. When I enable multicast the MDT tunnels are not built.If I cha...

Hi all, I hav given the Subnet 218.248.6.192/27for my Internet Router, and 210.212.218.24/29 for POS Links, i am able to get some websites thru some ip(218.248.6.192) and other some websites from other ip,could u help me out

Hi All, Are there any guidelines on the number of VRF's that can be configured on a particular platform and what is the impact of running a BGP context per VRF.In particular I am looking to get information on the Cat 6K platform and the following que...

I know that an ME6524 can be a u-PE in H-VPLS, but can you create a VPLS network using just ME6524's? All I have found so far are a few forum posts saying you need a 7600 or 6500 with an SPA/SIP/OSM card. Is there any definitive documentation on th...

I have setup basic MPLS switching between 5 routers. BGP is enable between Pescara and Pesaro with VRF routing for Customer A/B. if i do sh ip route vrf Customer_A and b on both routers, i cannot see the bgp routing for both customers even though bgp...

HI,Which MIB/OID is required to monitor the number of VPNv4 prefixes being advertised and received by a given ASBR in INTER_AS MPLS NNIRegards,GP

Hi everybodyMy question is: Is possible to associate an Level 3 Etherchannel to a vrf in a MPLS network inside a 7609 equipment with the following version: s72033-adventerprisek9_wan-mz.122-33.SRA5.bin. Thanks a lot

Hi, i have an MPLS backbone which is running sparse-mode. and i am trying to support Multicast for VRF's.. whats happening at the moment is when i configure MDT. The tunnels come up properlly. end to end ping works fine . but for only 1 icmp echo ...

Is there a way to configure MPLS TE to transfer traffic from one TE tunnel over to a 2nd or 3rd TE tunnel, after a certain threshold has been reached?For example, if TE tunnel #1 reaches a 75% of its capacity, can any additional traffic be shifted ov...