Dear All ,
I created a L2tunnel between two of my PE's and it is working fine . The Vlans are configured in dot1Q sub interfaces and then it is connected to trunk port of the switch . From the switch i can ping the other side PC ,so the l2 tunnel is working fine
Now my question is whether is there is any way to tunnel multiple VLAN through this ? I mean can we tunnel trunk link through the mentioned config or with xconnect command ?
password 0 test@test
protocol l2tpv3 test
ip local interface Loopback1
LocID RemID TunID Username, Intf/ State Last Chg Uniq ID
19216 25023 49489 101, Gi6/1.101:101 est 1w1d 15
You want to carry the entire trunk across the network by using port based eompls. You simply need to configure the xconnect under the physical (main) interface instead of the subinterface.
another option it might be done by using QinQ at the CE edge to tunnel the trunk under one VLAN ID and at the PE you can tunnel this vlan over L2VPN using one VLAN ID this similar concept to H-VPLS