Hi,
Iam looking for a way to Rate Limit - Vlan interfaces,
Somting like this .. or do I need to change the service-policy to rate-limit for it to work
!
Interface Vlan2
Description Customer-A
service-policy input police-customerA-traffic
service-policy output police-customerA-traffic
ip address 10.10.10.1 255.255.255.252
!
Interface Vlan3
Description Customer-B
service-policy input police-customerB-traffic
service-policy output police-customerB-traffic
ip address 10.10.11.1 255.255.255.252
!
Interface Vlan4
Description Customer-C
service-policy input police-customerC-traffic
service-policy output police-customerC-traffic
ip address 10.10.12.1 255.255.255.252
!
Interface GigabitEthernet3/1
Description Trunk - Customer-A - Customer-C
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 2,4
switchport mode trunk
!
Interface GigabitEthernet3/1
Description Trunk - Customer-B
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 3
switchport mode trunk
!
Is that posible ??, or do i need to make user based rate limit based on Source / destination adresses, and move the service policy to the physical interface ??
Hardware in this case Cisco 7609 running MPLS
Thanks in advance.
/Peter