VC down ME3600X

[oscar.garcia88]

Hi everyone!

We are facing a log on the device recently and the service on vlan stop responding. Do ypu have an idea how to fix this?

Could you explain what Remote peer withdrew label last error means?

[MHM Cisco World]

you run IOS XE ?
are you use PW backup ?
can you share the config ?

[oscar.garcia88]

.

[Harold Ritter]

Hi @oscar.garcia88 ,

It looks like you have no LDP binding to get to the remote endpoint. Can you provide the output for the following command from PE_ME_VILLAHERMOSA:

sh mpls ldp bindings 192.168.74.21 32

ping 192.168.74.21 source 192.168.64.208

ping mpls ipv4 192.168.74.21/32 source 192.168.64.208

Can you also provide the version you are running on the two PEs (PW endpoints)?

Regards,

[oscar.garcia88]

Thanks for your comments.

[oscar.garcia88]

Any idea or information that what could be the cause of the error "Remote peer withdrew label"?

Appreciate your comments.

[Harold Ritter]

Hi @oscar.garcia88 ,

I have seen similar issues related to the utilization of port-channels as core interfaces. I see you are using port-channels. It could be what the issue is. Let me check if I can find the relate bug id.

Is there any way you can try removing the port-channel interface as use the physical interface instead?

Regards,

[oscar.garcia88]

In this case is not posible to physical interfaces instead port-channel, if you have the relate bug id that would be great!

Appreciate your comments.

[oscar.garcia88]

Hi @Harold Ritter 

Could you find the related bug id of this issue?

Appreciate your comments.

[Harold Ritter]

Hi @oscar.garcia88 ,

After checking the version you are running on the ME3600, the bug id I referred to does not apply. 

I see you have recently opened a TAC case for this issue. TAC will certainly find the root cause.

Regards,

[oscar.garcia88]

Hi @Harold Ritter 

Do you have any helpful link related to VC errors?

Appreciate your comments.

[Harold Ritter]

Hi @oscar.garcia88 ,

The issue with the error code you are getting ("Last error: Remote peer withdrew label
") is that it can be caused by a variety of issues. The only way to really find out what it really means is to thoroughly troubleshoot. Hope you are getting good progress with TAC.

Regards,