802.1X Authentication on 4507 switch using AD

[techguy]

Hi,

I want to implement 802.1X authentication on Cisco 4507 switch. Authentication should be done thru Microsoft Active directory. Can someone guide me in this regard? Thanks

[nspasov]

Before you proceed with 802.1x based configuration make sure that your switch/Supervisor supports dot1x. Depending on the type of Radius server you are using the compatibility might change but here is the compatibility guide for Cisco's ISE:

http://www.cisco.com/c/en/us/td/docs/security/ise/1-3/compatibility/ise_sdt.html

With regards to configurations. Have a look at the following link (Again assuming you are using ISE):

http://www.cisco.com/c/en/us/support/security/identity-services-engine/products-implementation-design-guides-list.html

Thank you for rating helpful posts!